RAM Mount Motorcycle M8 Handlebar Universal Finger Grip Kit

SKU:
RAM-B-367-UN4U
$62.50

or make 4 interest-free payments of $15.62 AUD fortnightly with Afterpay More info

RAM Motorcycle Handlebar Clamp with Double Socket Arm & Universal Finger Grip

The RAM-B-367-UN4 consists of a M8 bolt base, double socket arm and universal Finger Grip cradle.

This base is the starting point for the easiest way to mount your GPS Device to your motorcycle. It suits all handlebar clamps that use a M8 bolt. Choose a short or long arm and a suitable ball mount for your cradle and you are ready to go.

Your motorcycle rides on rubber tyres for grip and to soften the ride. Why should it be any different for your mounted electronics? With RAM's patented rubber ball and socket technology, the turn of a single knob grips the adjustment arm to a rubber ball designed to dampen shock and vibration.

With RAM products, it's all grip and no slip plus protection for your valuable electronics. Simply place our easy to install ball base onto the motorcycle handlebar top clamp and you're done. After that, a world of mounting possibilities just opened up.

The universal finger cradle is designed to hold a broad range of UHF Radios, GPS devices, smartphones and other electronic devices. The cradle comes with three different lengths of flexible rubber coated fingers to grip your device. Simply choose the length of finger that best suits your device. The fingers open by squeezing the ends to open the small finger arms.

The bottom of the cradle includes a back plate that adds support to the device being held by the mount. This mount is highly recommended for securing handheld two way radios and scanners.

Height Dimensions:
Minimum with Top and Bottom Plates: 133mm (5.25")
Maximum with Top and Bottom Plates: 152mm (6.0")
The top and bottom plates can be removed for larger devices.

Spine Plate Dimensions:
63mm x 127mm (2.5" x 5") Width x Height

Using Short Arm Side Clamps:
Maximum Depth: 19mm (0.75")
Minimum Width: 32mm (1.25")
Maximum Width: 76mm (3.0")

Using Medium Arm Side Clamps:
Maximum Depth: 32mm (1.25")
Minimum Width: 38mm (1.5")
Maximum Width: 89mm (3.5")

Using Long Arm Side Clamps:
Maximum Depth: 40mm (1.6")
Minimum Width: 57mm (2.25")
Maximum Width: 89mm (3.5")

Compatible motorcycles:
Any motorcycle which employs an 8mm bolt or smaller on its structure. A smaller bolt can be used, though the load capacity decreases with the bolt size.

Included in this kit:
• 1 x M8 x 55mm bolt (1.25 thread pitch)
• 1 x M8 x 60mm bolt (1.25 thread pitch)
• 1 x M8 x 65mm bolt (1.25 thread pitch)

Attachment Point:
Motorcycle handlebar top clamp, any bike that uses an M8 threaded bolt.

Material:
Powder Coated Marine Grade Aluminium & High Strength Composite

Note:
To determine if these bolts are compatible with your motorcycle measure the bolt for the diameter and add 30mm to the length. If it matches one of the 55, 60, or 65 mm length, then you can use the appropriate bolt supplied with the mount. If it does not match, you may be able to source the correct length of bolt locally. Be sure to use the correct torque spec when attaching the mount.

Downloads:
Finger Grip Assembly Instructions

 

Shipping Cost:
Calculated at Checkout
Weight:
100.00 Grams
Width:
9.00 (cm)
Height:
2.50 (cm)
Depth:
7.00 (cm)